Cylinder for testing the Renco backfat measuring device
5047
Cylinder for testing the correct functioning of the Renco backfat measuring device.
Directions for use:
- Wet the end of the probe or the cylinder and introduce the probe in the cylinder.
- The opposite end of the cylinder must not come into contact any surface, and the hole of the cylinder must not be covered.
- The reading must be approximately 25 mm, depending on the humidity, and approximately 30 mm for the devices purchased in Australia and New Zealand.
- The real reading figure is not as important as obtaining a reading.
- In case of any problem most probably a reading will not be obtained.
Related products
€63.44 + VAT
€76.76 VAT included
Expected Date: 04/23/2024
Comments